Interface For Pc Clip Studio Mac Or PC
Interface For Pc Clip Studio Manual For More
Interface For Pc Clip Studio Driver If One

Given the ability for digital patching and for sending audio through multiple sources (including Network sources from our StudioLive Rack mixers and NSB stageboxes), the purpose of this article is to instruct on using USB connection for playback and recording, in a simple way that can get you started.

Interface For Pc Clip Studio Mac Or PC

First, the information listed on these KB articles below are necessary to learn general playback audio from your Mac or PC computer.

It is suggested to go through these articles to learn how to route this audio, and the setup expressed will get you prepared to follow the Studio One instructions further.

Interface For Pc Clip Studio Driver If One

By default, it will choose a PreSonus driver if one is available.

In the Options window, click on the Audio Setup tab and select your device driver from the pull-down.

Make sure to select the appropriate sampling Rate the interface is using (This is found on the console mixer under Home System, or on your Rackmount by hitting the Gear in the upper left hand corner and looking at Device Settings).

Note that AVB routing already has a template you can select in Step 1.

Interface For Pc Clip Studio Manual For More

In this section, you will be creating the assignment for the Main Output of Studio One, and any Cue Mixes you want to create on the StudioLive (this is expressed in the Studio One Integration Manual for more information if you want to do a more advanced setup).

If you have not done so, please go back to the beginning of this article and follow the appropriate routing setup.

The Main Output for Studio One should be assigned in the Output tab as depicted to 37 and 38 as this was also the outputs you setup for the general playback in the console by default.

To make the settings recall every time you open a New Song that is an Empty Song, make sure to click at this time the Make Default button on the dialog box.

This will help you to not have to set this back up after doing it once already.

Press the TAB key to edit the next name on the Left Hand Side.

Then press OK and this should take you back to the arrange window.

When pressing the Tape Input Button on your console, you should now have the ability to select the USB source and control of the Tape Input from this menu.

An example of where the Digital Return is on UC Surface on a Rackmount mixer is below as well.

The input source is USB and the audio recorded that is played back returns to that fader.

Mac Interface For Pc Clip Studio